First, heating system
1. The introduction of the power supply and the removal of the temperature signal are performed by a carbon brush.
2. The heating element for heating the rotating body adopts an electric heating tube.
3. The heating rotor is pressurized by a cylinder.
Second, corrective and guiding system
1, eight sets of corrector.
2. Corrector distribution: two sets of non-woven fabrics on both sides, a set of intermediate non-woven fabrics, one set of elastic waist, one set of non-woven layer of guide layer, and three sets of side belts.
Third , other controls
1, three-color warning light, automatic alarm function.
2. Schneider low-voltage electronic control components.
3. The rotating body with phase requirement can realize phase adjustment without stopping.
4, with the hot melt adhesive, can achieve automatic glue, automatically stop when the machine stops, can also achieve manual control. (The glue machine and the glue controller are self-contained).
5. Configure the inspection lighting (safety voltage: 36V) spray station and rear drive observation light, and the drive side is equipped with emergency stop safety cable.
6, automatic product counting